Dss-networks C5468 Instrukcja Użytkownika Pobierz pdf (Strona 27)

GigMAC-CPCI-3U Network Interface Cards

Gig-CPCI-3U Gigabit Ethernet Switches Board and Driver Users Manual

DSS NETWORKS, INC. DocVersion: 1.2 Page: 27

Using dmUtil dpm driver utility:

The “dpm driver utility” is used to capture detailed board levels statistics, controller

registers and to set loopback mode. Example usage of the “dmUtil” are as follows:

dmUtil -s eth1 # get driver statistics for interface 1

dmUtil –p eth1 # get phy (transceiver) registers for interface 1

dmUtil –m eth1 # get MAC (PCI controller) registers for interface 10

dmUtil –t eth1 # get execution debug trace for interface1

(DEBUG_FLAGS trace option must be compiled in)

dmUtil –e eth1 # get eeprom configuration settings

dmUtil –ms eth1 # get mac MIB statistics

dmUtil –a eth1 # get mac address

dmUtil –w eth1 <0,1,2> # write default eeprom configuration to controller

dmUtil –l eth1 <arg> # set controller in internal loopback mode

(driver must be compiled with –DNS_FRAME_TEST

in Makefile). Arg=1 for enable, 0 for disable.

10.2 VXWORKS DRIVER INSTALLATION AND USAGE

Driver utility shell commands for vxWorks driver operation are shown in the next

section.

Please also see the vxWorks OEM Developers Guide p/n 131901 for vxWorks software

installation and integration instructions.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Brak uwag

Dss-networks C5468 Instrukcja Użytkownika Strona 27